6.9 Communication settings example when JP1/Base is operating within a specific network in an environment with multiple networks

This section explains how to specify the communication settings when JP1/Base is operating within a specific network in an environment with multiple networks, based on the system configuration example shown in the following figure.

Figure 6‒8: System configuration example when using JP1/Base (within a specific network in an environment with multiple networks)

The above figure assumes that hostL (a logical host) is a manager host, and that JP1/Base on each host is connected through network 2.

Organization of this section

• 6.9.1 Changing communication settings (with jp1hosts information)

• 6.9.2 Changing communication settings (with jp1hosts2 information)

To Page Top