6.6.3 Changing communication settings for event services
In versions 09-00 and earlier of JP1/Base, the event service was limited to the communication settings defined in the event server settings file (conf). However, from JP1/Base version 10-00, the event service can use the same communication settings as JP1/Base. In most circumstances, the same communication setting as JP1/Base can be used by following the procedures in 6.6.1 Issues when using JP1/Base in an environment of distinct networks (with jp1hosts2 information).
Although you can apply dedicated communication settings for the event server in the same way as in JP1/Base version 09-00 and earlier, you cannot use IPv6 addresses to communicate if you do so.
- Note
-
The event service does not support the communication protocols of JP1/Base 06-51 or earlier, but does support communication protocols of JP1/Base 06-71 or later. For the differences between the communication settings of JP1/Base 06-51 or earlier and JP1/Base 06-71 or later, see H.11 Differences between communication protocols of JP1/Base 06-51 or earlier and JP1/Base 06-71 or later.