4.2.3 Changing the health check settings

To add a target host or change the monitoring interval:

1. Edit the health check definition file (jbshc.conf).

   For details on the health check definition file, see Health check definition file in 16. Definition Files.

2. Apply the new settings in the health check definition file (jbshc.conf).

   Restart JP1/Base, or execute the jbs_spmd_reload command. For details on the jbs_spmd_reload command, see jbs_spmd_reload in 15. Commands.

   The reloaded settings apply at the next monitoring round.

   If an error occurs at reload due to an error in the health check definition file (jbshc.conf), that line is ignored and the previous setting applies.

Note on reloading settings

If the settings are reloaded after an error has been detected during remote host monitoring, the monitoring status at the target host will be reset. If the failed host has not been restored when next polled, the health check function issues an error message or JP1 event again. If the failed host has been restored, no recovery message or JP1 event is issued.

To Page Top