7.3.1 Setting up the adapter command
- Organization of this subsection
(1) Setup
-
Execute the setup command provided by each linked product.
-
The adapter command settings file is generated in the following location:
- In Windows:
-
JP1/Base-installation-folder#\plugin\conf
- In UNIX:
-
/opt/jp1base/plugin/conf
- #
-
The folders below are the default installation locations for each product. Note that system-drive:\ProgramData represents the location determined by the OS environment variable during installation, and thus it may vary depending on your environment.
In an x86 environment: system-drive:\Program Files\Hitachi\JP1Base
In an x64 environment: system-drive:\Program Files (x86)\Hitachi\JP1Base
- Important
-
-
In Windows, the installation directory of JP1/Base is retrieved from the following registry entry:
HKEY_LOCAL_MACHINE\SOFTWARE\HITACHI\JP1BASE\PATHNAME\PATH00
-
If there is a file with the same name at the location where the file is to be stored, the file is overwritten.
-
Do not stop the JP1/Base service.
-
(2) Unsetup
-
Execute the unsetup command provided by each linked product.
-
Remove the adapter command settings file manually.
- Important
-
-
Do not stop the JP1/Base service.
-
When you uninstall a linked product, the adapter command settings file is also uninstalled.
-