Settings file for the completed-action linkage function (action_complete_xxx.conf)

Format

[logical-host-name\JP1SCOPE\BMS]
"ACTION_COMPLETE_MODE"=dword:value

To Page Top

File

action_complete_on.conf (used to enable the completed-action linkage function)

action_complete_off.conf (used to disable the completed-action linkage function)

To Page Top

Storage directory

In Windows

For a physical host:

Scope-path\conf\

For a logical host:

shared-folder\jp1scope\conf\

In UNIX

For a physical host:

/etc/opt/jp1scope/conf/

For a logical host:

shared-directory/jp1scope/conf/

To Page Top

Description

This file defines whether the completed-action linkage function is to be enabled.

When the function is enabled, the status of a monitoring object changes on Central Scope according to the JP1 event action status at Central Console.

In JP1/IM - Manager that has been installed as a new installation, this function is enabled. In JP1/IM - Manager that has been installed as an upgrade installation, the same setting that was specified in the previous version is initially retained.

To Page Top

When the definitions are applied

The definition takes effect after JP1/IM - Manager is restarted by executing the jbssetcnf command.

To Page Top

Information that is specified

[logical-host-name\JP1SCOPE\BMS]

Specifies the key name for the JP1/IM environment settings.

For logical-host-name, specify JP1_DEFAULT for the physical host and logical-host-name for a logical host.

"ACTION_COMPLETE_MODE"=dword:value

• The value of action_complete_on.conf is 00000001.

• The value of action_complete_off.conf is 00000000.

Do not edit this parameter.

To Page Top