Hitachi

JP1 Version 12 JP1/Integrated Management 2 - Event Gateway for Network Node Manager i


Lists of commands

This section provides lists of the commands that can be used in JP1/IM - EG for NNMi. The tables indicate each command's support under Windows and UNIX as follows:

Legend:

Y: Supported

--: Not supported

#

For commands that are also available in Windows, read the footnoted instances of Superuser permissions in the Required execution permissions column of the first table below as Administrator permissions.

Following the tables, the commands are described in alphabetical order.

Organization of this page

Commands related to startup, termination, and setup

Overview of function

Command name

Windows

UNIX

Required execution permissions

Sets up JP1/IM - EG for NNMi

jegn_setup

Y

Y

Superuser permissions#

Starts JP1/IM - EG for NNMi automatically

jegn_start (UNIX only)

--

Y

Superuser permissions

Terminates JP1/IM - EG for NNMi automatically

jegn_stop (UNIX only)

--

Y

Superuser permissions

Checks the status of JP1/IM - EG for NNMi processes

jegn_spmd_status

Y

Y

Superuser permissions#

Updates the status of JP1/IM - EG for NNMi processes

jegn_spmd_reload

Y

Y

Superuser permissions#

Specifies settings required for operation in a cluster system

jegn_setup_cluster

Y

Y

Superuser permissions#

Starts JP1/IM - EG for NNMi in a cluster system

jegn_start.cluster (UNIX only)

--

Y

Superuser permissions

Terminates JP1/IM - EG for NNMi in a cluster system

jegn_stop.cluster (UNIX only)

--

Y

Superuser permissions

Forcibly terminates JP1/IM - EG for NNMi in a cluster system

jegn_killall.cluster (UNIX only)

--

Y

Superuser permissions

Commands used for troubleshooting

Overview of function

Command name

Windows

UNIX

Required execution permission

Collects data after a problem has occurred in JP1/IM - EG for NNMi

jegn_log.bat (Windows only)

Y

--

Administrator permissions

jegn_log.sh (UNIX only)

--

Y

Superuser permissions