2.3.1 Installation procedure
JP1/IM - EG for NNMi requires JP1/Base as a prerequisite product. You must install JP1/Base before you can install JP1/IM - EG for NNMi.
Before installing JP/IM - Manager, confirm that the temporary directory (/tmp) has 1 MB of free space.
The following table lists the language type for JP1/IM - EG for NNMi that is specified based on the environment variables file configured during the setup after installation of JP1/IM - EG for NNMi.
Value of environment variable LANG in the environment variables file (jegn_env.conf) |
Language type |
---|---|
ja_JP.UTF-8, ja_JP.utf8, ja_JP.SJIS, or ja_JP.sjis |
Japanese |
C |
English |
Other than above |
To install JP1/IM - EG for NNMi:
-
Terminate the programs.
Stop the JP1/Base services.
Stop the NNMi services.
Stop the JP1/IM - EG for NNMi services.
-
Run Hitachi Program Product Installer.
Follow the instructions of Hitachi Program Product Installer. For details about how to use Hitachi Program Product Installer, see 2.3.3 How to use Hitachi Program Product Installer.
- About remote installation using JP1/Software Distribution
-
Remote installation (software distribution) by JP1/Software Distribution is supported for JP1/IM - EG for NNMi. For details about how to use JP1/Software Distribution to perform remote installation, see Job Management Partner 1/Software Distribution Administrator's Guide Volume 1.
- About overwrite installation and upgrade installation
-
Before you perform an overwrite installation or upgrade installation of JP1/IM - EG for NNMi, stop the services of JP1/IM - EG for NNMi.