1.4 NNMi incident conversion procedure
JP1 events obtained by converting NNMi incidents are registered into the event database that is provided by the event service of JP1/Base, where they are managed in the same manner as with JP1 events issued by JP1-series programs. The figure below shows the procedure for converting NNMi incidents into JP1 events and then registering them into the JP1/Base event database. The numbers in the figure indicate the sequence of the steps in the procedure.
The following describes each step shown in the figure.
To convert NNMi incidents:
-
Load definition files.
When JP1/IM - EG for NNMi starts, the definition files listed below are loaded:
-
NNMi incident forwarding filter definition file
-
Mapping definition file
-
-
Acquire NNMi incidents from NNMi periodically.
Periodically, JP1/IM - EG for NNMi issues NNMi incident acquisition requests to NNMi. If any applicable NNMi incidents have occurred, JP1/IM - EG for NNMi acquires them.
-
Convert the NNMi incidents into JP1 events.
JP1/IM - EG for NNMi converts into JP1 events only those acquired NNMi incidents that match the filter conditions specified in the NNMi incident forwarding filter definition file.
-
Register the JP1 events into the event database of JP1/Base.
JP1/IM - EG for NNMi uses the event service of JP1/Base to register the JP1 events into the event database.