KNAN22531-E
Application of log file trap contents failed because an error occurred when the reload command was executed. (Cause: detailed-information. error code: error-code. For details, see the description of the jevlogreload command in the JP1/Base manual.)
A log file trap could not be applied because an error occurred during execution of the reload/start command.
- S:
-
Stops the application of the configuration file.
- O:
-
If the following detailed information is displayed, perform the indicated corrective action.
-
There is a mistake in the settings.
Correct the mistake, and then re-execute the command.
-
A parameter other than MARKSTR and ACTDEF was changed.
If you want to reload the configuration file, make sure the values of parameters other than MARKSTR or ACTDEF match the values on the Valid Configuration Information page, and then re-execute the command.
If you want to change a parameter other than MARKSTR or ACTDEF, select Apply by Restarting, and then restart the log file trap.
For details about error codes, see the description of the jevlogreload command in the JP1/Base User's Guide.
-