KAVB4909-E

An attempt to set locale information failed because a locale that is not supported by the OS was set.

S:

• If the error message is output during startup of the manager, the system assumes that the locale is C and continues processing, but operation is inconsistent.

• If the error message is output while opening the Action Parameter Definitions window or clicking the Apply button in the Action Parameter Definitions window, the system terminates the operation.

• If the error message is output during execution of the jcamakea command, the system aborts processing.

O:

• If the error message is output during startup of the manager, make sure that the LANG value in the jp1co_env.conf file is a value that can be specified, and then restart the manager.

• If the error message is output while opening the Action Parameter Definitions window or clicking the Apply button in the Action Parameter Definitions window, check the environment variable value, restart, and then try the operation again.

• If the error message is output during execution of the jcamakea command, make sure that the LANG environment variable value of the execution environment is a value that can be specified.

• If the locale environment variable (LC_ALL, LC_COLLATE, LC_CTYPE, LC_MONETARY, LC_NUMERIC, LC_TIME, LC_MESSAGES) was specified, execute the unset command for the locale environment variable, and then retry the operation.

If the system is unable to recover after corrective action is taken, execute the locale -a command to determine whether the locale (the value of the LANG environment variable) was specified in the OS. If the locale was not specified, specify it.