KAVB3107-E

Configuration information could not be set in certain hosts during configuration definition confirmation.

S:

Places the jbsrt_distrib command in error status.

O:

On the host that has the error, check the following items:

• Is JP1/Base running? (Can be checked with the jbs_spmd_status command.)

• Is the configuration management port (initialized to 20237/tcp) running? (Can be checked with the netstat command.)

• Is the configuration management port (initialized to 20237/tcp) being filtered by a firewall or similar utility?

• Is it possible to resolve the name of the host that has the error from a higher-level host than the host that has the error? (Can be checked with the jp1ping command.)

• Is the IP address found by resolving the name of the intended IP address?

• Was the host that has the error previously defined as the highest-level host? (Can be checked with the jbsrt_get command.) If the configuration definition information from when it was the highest-level host remains, execute the jbsrt_del command to delete the configuration information.

• Has a memory shortage occurred?

• Are there write and read permissions for the conf/route/ directory?

If the problem is other than the above, check the following items in the host that has the error:

1. Execute the jbsrt_get command.

2. Determine whether any of the following have occurred:

   • Was a KAVB3162-E message output?

   • Did the jbsrt_get command end abnormally?

   • Is the local host name displayed as a higher-level host or a lower-level host?

   • Is a host name other than the local host name displayed as the local host?

   • Is the host name misspelled?

3. If any of the above occurred, use the following method to recover from the error:

   1. Execute the jbsrt_del command to delete the configuration definition information.

   2. On the manager host, execute the jbsrt_distrib command to redistribute the configuration definition information.