KAVB1017-W

The command button being loaded was disabled.

S:

Disables the command button that is being read, and continues loading.

O:

There is an error in the specified parameter. Review and correct the definition in the command button definition file referencing the detailed information and line number indicated in the message.

• If the number of command buttons exceeds the maximum value, delete or comment out unnecessary command buttons.

• If a command button name is not specified, specify a command button name.

• If the length of a command button name exceeds the maximum number of characters, reduce the characters in the command button name to less than the maximum.

• If the cmd parameter is not specified, specify it.

• If a command line is not specified, specify a command line.

• If the command line length exceeds the maximum number of bytes, change the command line so that its length does not exceed the maximum.

• If an environment variable file name is not specified, specify the environment variable file name.

• If the length of an environment variable file name exceeds the maximum number of bytes, change the file name so that its length does not exceed the maximum.

• If an execution host name is not specified, specify the execution host name.

• If the length of an execution host name exceeds the maximum number of bytes, change the execution host name so that its length does not exceed the maximum.

• If the same command button name is specified more than once, change the command button name.

• If a command button name contains control characters, delete them from the command button name.

• If there is an error in the specification of the btn or end-btn parameter, check the combination of the btn and end-btn parameters, and then correct the error.