Settings file for the completed-action linkage function (action_complete_xxx.conf)
- Organization of this page
Format
[logical-host-name\JP1SCOPE\BMS] "ACTION_COMPLETE_MODE"=dword:value
File
action_complete_on.conf (used to enable the completed-action linkage function)
action_complete_off.conf (used to disable the completed-action linkage function)
Storage directory
- In Windows
-
- For a physical host:
-
Scope-path\conf\
- For a logical host:
-
shared-folder\jp1scope\conf\
- In UNIX
-
- For a physical host:
-
/etc/opt/jp1scope/conf/
- For a logical host:
-
shared-directory/jp1scope/conf/
Description
This file defines whether the completed-action linkage function is to be enabled.
When the function is enabled, the status of a monitoring object changes on Central Scope according to the JP1 event action status at Central Console.
In JP1/IM - Manager that has been installed as a new installation, this function is enabled. In JP1/IM - Manager that has been installed as an upgrade installation, the same setting that was specified in the previous version is initially retained.
When the definitions are applied
The definition takes effect after JP1/IM - Manager is restarted by executing the jbssetcnf command.
Information that is specified
- [logical-host-name\JP1SCOPE\BMS]
-
Specifies the key name for the JP1/IM environment settings.
For logical-host-name, specify JP1_DEFAULT for the physical host and logical-host-name for a logical host.
- "ACTION_COMPLETE_MODE"=dword:value
-
-
The value of action_complete_on.conf is 00000001.
-
The value of action_complete_off.conf is 00000000.
Do not edit this parameter.
-