3.24.3 Command Execution page

The Command Execution page is used to set the maximum number of lines that display command execution results.

The following figure shows the Command Execution page.

Figure 3‒51: Command Execution page

The following describes the items displayed on the Command Execution page.

Lines of execution results to display

Specifies the maximum number of lines available for displaying execution results in the Execute Command window.

You can specify a value from 100 to 10,000 (lines). The default is 10,000.

This area is enabled only when the logged-in user has JP1_Console_Admin permission or JP1_Console_Operator permission.