1.1.4 Recovery (in UNIX)
This subsection explains how to recover the JP1/IM configuration information.
Before you recover JP1/IM backup information, you must first recover JP1/Base. Make sure that the following prerequisite conditions are met, and then recover the backup files to their original locations.
- Prerequisite conditions:
-
-
JP1/Base has been installed, and the setup command has already been executed.
-
JP1/IM - Manager has been installed, and the setup command has already been executed.
-
To recover a logical host environment, JP1 must already be set up in the logical host environment.
-
JP1/Base and JP1/IM - Manager are stopped.
-
Backup information is recovered only for the host of the environment that was backed up. To recover backup information, you must perform a recovery operation in each environment.
If the system operates in a cluster configuration, recover each environment in the order of physical hosts, then logical hosts.