10.3.1 Settings for enabling the JP1/IM - Rule Operation linkage function
This subsection explains how to specify settings to enable the JP1/IM - Rule Operation linkage function. You can perform the steps described below in any order. You can also perform the procedure in a single operation by specifying multiple arguments.
To enable the JP1/IM - Rule Operation linkage function:
-
Enable the JP1/IM - Rule Operation linkage function.
Execute the following command:
jcoimdef -rule ON
-
Specify the JP1/IM - Rule Operation host.
Execute the following command:
jcoimdef -rulehost JP1/IM-Rule-Operation-host-name
-
Specify the JP1 user who is to be notified of any event that results in issuance of a rule startup request to JP1/IM - Rule Operation.
Execute the following command:
jcoimdef -ruleuser JP1-user-name
If you have enabled or disabled the JP1/IM - Rule Operation linkage function while JP1/IM - Manager was running by executing the jcoimdef command with the -rule option specified, you must restart JP1/IM - Manager. You must also restart the JP1/IM - View that is connected.
You must execute the jcoimdef command with the -i option specified or the jco_spmd_reload command in either of the following situations: You changed the JP1/IM - Rule Operation host while JP1/IM - Manager was running by executing the jcoimdef command with the -rulehost option specified, or you specified the JP1 user who is to be notified of an event that results in issuance of a rule startup request to JP1/IM - Rule Operation by executing the jcoimdef command with the -ruleuser option specified. There is no need to restart the JP1/IM - View that is connected.
- About the settings for enabling the JP1/IM - Rule Operation linkage function:
-
-
About the jcoimdef command
See jcoimdef in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.
-