7.7.2 Using commands to change settings (for Windows)
If you have used the jcochafmode, jcochcefmode, or jcocmddef command to change settings, you must also specify the same settings at the primary and secondary servers.
-
When the jcochafmode command was executed
If you have changed the location of the event acquisition filter by specifying the -h option, you must copy the common definition information from the primary server to the secondary server.
Copy the common definition information using the setup procedure described in 7.3.4 Copying the common definition information during new installation (for Windows).
-
When the jcochcefmode command is executed
If you have changed the operation mode for the common exclusion conditions by specifying the -h option, you must copy the common definition information from the primary server to the secondary server.
Copy the common definition information using the setup procedure described in 7.3.4 Copying the common definition information during new installation (for Windows).
-
When the jcocmddef command was executed
If you have changed the settings at the primary server by specifying the -host option, you must also specify the same settings at the secondary server. You can execute the jcocmddef command even when the shared disk is not mounted.