7.4.1 Registering into the cluster software (for Windows)
- Organization of this subsection
(1) In MSCS (Microsoft Cluster Service) or WSFC (Windows Server Failover Cluster)
Register the services of JP1/IM - Manager and JP1/Base as MSCS or WSFC resources. Set each resource as described below. Bold type indicates an MSCS setting item. For details about how to set WSFC, see the WSFC manual.
-
For Resource Types, register as Generic Service.
-
Set Name, Dependencies, and Service name as shown in the table. The name is used to display the service, and the service name is used to specify the service that is controlled from MSCS.
-
Do not set Start parameters and Registry Replication.
-
Set the Advanced page for properties according to whether failover is to occur in the event of a JP1/IM - Manager failure.
For example, to set failover to occur in the event of a JP1/IM - Manager failure, select the Restart and Affect the group check boxes and specify Threshold for the restart retry count. Use 3 (times) as a guideline for the value to be specified.
(2) When registering the service start and stop commands
Register into the cluster software JP1/IM - Manager and the JP1/Base services to be started and stopped. For example, specify the settings so that the services shown in the Name column in the table above will be started and stopped by the net command.
To check the operation of JP1/IM - Manager and JP1/Base, use the following commands:
-
jco_spmd_status
Use this command to check the operation of JP1/IM - Manager (except the IM databases).
-
jimdbstatus
Use this command to check the operation of the IM databases (when the IM databases are used).
-
jbs_spmd_status
Use this command to check the operation of JP1/Base.
-
jevstat
Use this command to check the operation of JP1/Base Event Service.
For details about how to use these commands, see 8.4 Registering into the cluster software during new installation and setup (for UNIX).