6.8.6 Setup for linkage with JP1/PAM
- Organization of this subsection
(1) Setup for using system-monitoring objects for monitoring
To use a system-monitoring object of JP1/PAM, you must set JP1/PAM to issue JP1 events.
For details about the linkage setup, also see the following manual:
-
Description of JP1/PAM
See the manual JP1/Performance Management - Analysis Description, Operator's Guide and Reference.
(a) For the JP1/PA - Manager host
To perform setup at the manager where JP1/PA - Manager is installed:
-
Enable JP1 event issuance by JP1/PAM.
Set the JP1 event issuance definition file (pamjp1ev.conf) for JP1/PAM as follows:
-
File to be set
pamjp1ev.conf
-
Settings
Specify Y for the settings as to whether to issue JP1 events (jp1evt_flag) and whether to issue each JP1 event (such as metricNW). For the settings as to whether to issue each JP1 event, specify Y for all events.
jp1evt_flag=Y
metricNW=Y
:
-