5.14.3 Procedure for issuing events after display messages have been changed

The following explains the procedure for issuing events after display messages have been changed:

1. Edit the environment definition file for events after the display message is changed.

   Specify 00000001 for "SEND_CHANGE_MESSAGE_EVENT"=dword:.

   For details about the environment definition file for events after the display message is changed, see Environment definition file for events after the display message is changed (chmsgevent.conf) in Chapter 2. Definition Files in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.

2. Execute the jbssetcnf command.

   Execute the jbssetcnf command of JP1/Base to apply the contents of the environment definition file for events after the display message is changed to the JP1 common definition information. For details about the jbssetcnf command, see the JP1/Base User's Guide.

3. Restart JP1/IM - Manager.

   Events will be issued after display messages have been changed. For this reason, set event ID 00006400 in the exclusion conditions using an event acquisition filter so that the same events will not be acquired again. For details about event acquisition filters, see 5.2.4 Settings for event acquisition filters.

To Page Top