2.17.4 Specifying settings for using the functions of Central Scope (for UNIX)

When a new installation of JP1/IM - Manager is performed, the functions of Central Scope are disabled by default.

To use the functions of Central Scope:

1. Create a Central Scope database.

   Execute the jcsdbsetup command.

2. Enable Central Scope Service (jcsmain).

   Execute jcoimdef -s ON.

3. Restart JP1/IM - Manager.

4. Verify that Central Scope Service is running.

   Execute the jco_spmd_status command. Make sure that jcsmain is displayed as an active process.

For details about the jcsdbsetup command, see jcsdbsetup in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.

For details about the jcoimdef command, see jcoimdef in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.

To Page Top