13.8.1 System design for linking with JP1/IM - Rule Operation
To link with JP1/IM - Rule Operation, the following setup is required on the JP1/IM side. For details about JP1/IM - Rule Operation, see the Job Management Partner 1/Integrated Management - Rule Operation System Configuration and User's Guide.
- Organization of this subsection
(1) Settings for JP1/IM - Rule Operation linkage
The following settings are required for linking with JP1/IM - Rule Operation:
- Settings for JP1/IM - Rule Operation linkage (jcoimdef command)#
-
-
Enable or disable JP1/IM - Rule Operation linkage (-rule option)
-
Specify the JP1/IM - Rule Operation host (-rulehost option)
-
Specify the execution user (-ruleuser option)
#: Enabling the linkage function enables the notification condition settings to be exported from JP1/IM - View to JP1/IM - Rule Operation.
-
- Condition for notifying JP1/IM - Rule Operation
-
Set in either of the following:
-
Action Parameter Detailed Definitions window
-
Automated action definition file (actdef.conf)
-
- Display settings
-
-
Preferences window
-
Settings for View Filter window
-
Severe Event Definitions window
-
Detailed Settings for Event Receiver Filter window
-
- Registration in the Start menu of JP1/IM - View (rule operation viewer)
-
-
jcovrmsetup command
-
(2) Notes
-
In the JP1/IM - Rule Operation notification conditions, specify all the JP1 events that could potentially match a rule startup condition. (Rule startup judgments for notifications from JP1/IM - Manager are performed on the JP1/IM - Rule Operation side.)
-
Reporting to JP1/IM - Rule Operation is performed according to the system hierarchy (IM configuration) as is usual for automated actions.
For this reason, if you want to run JP1/IM - Manager and JP1/IM - Rule Operation on different hosts, you must configure the JP1/IM - Rule Operation host at a level below the JP1/IM - Manager host.
-
The following problems occur if you enable JP1/IM - Rule Operation linkage and set a notification condition, and then disable the function without first deleting the condition settings:
-
Automated actions cannot be set from JP1/IM - View.
-
Because the notification conditions in JP1/IM - Manager are still in effect, JP1/IM - Manager will send a rule startup request to JP1/IM - Rule Operation whenever a JP1 event matching a notification condition occurs.
To prevent such problems, before you disable the linkage function, delete the condition settings for notifying JP1/IM - Rule Operation from JP1/IM - View, or open the automated action definition file (actdef.conf) and delete the automated action definition parameter for JP1/IM - Rule Operation linkage. For details about the automated action definition file (actdef.conf), see Automated action definition file (actdef.conf) in Chapter 2. Definition Files in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.
-
-
JP1/IM - Rule Operation issues a JP1 event whenever a rule starts, finishes, or ends abnormally, for example. If you want to monitor such JP1 events in JP1/IM, change the filter settings so that they can be forwarded and displayed in JP1/IM - View.