Hitachi

JP1 Version 12 JP1/Integrated Management 2 - Manager Overview and System Design Guide


8.2.2 Enabling and disabling the health check function

The health check function is not enabled at installation.

If you use the health check function, in the health check definition file, set the parameter that enables or disables health checking (ENABLE) to true. To issue a JP1 event or execute a notification command when a process hangs, enable the EVENT parameter, and specify the command to be executed using the COMMAND parameter.

To initiate a failover in a cluster system when the health check function detects a process error, you must enable the FAILOVER parameter in the health check setup file. When this setting is enabled, JP1/IM - Manager is stopped when the health check function detects a process error, allowing failover to take place.

For details about the definition file, see Health check definition file (jcohc.conf) in Chapter 2. Definition Files in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.