5.3.2 Changing the application configuration
After editing the configuration file, change the application configuration by applying the edited settings to the system. Perform the procedure below to change the application configuration.
- Important
-
For all installations other than a new installation, make sure that the database service is running. If it is not running, start it, and then perform the procedure below.
- Organization of this subsection
(1) Starting the JP1/DH Web application server
Execute either of the following batches:
-
In Windows
installation-folder\setup_util\start_webcon.bat
-
In Linux
/opt/jp1dh/server/setup_util/start_webcon.sh
When you execute the batch, the command prompt starts. Follow the given instructions. If the message below appears, the JP1/DH Web application server is running properly. Do not close the command prompt. Go to the next step.
... KDJE30028-I The J2EE server has started. Server name = jp1dh
(2) Preparing to change the application configuration
Execute either of the following batches:
-
In Windows
installation-folder\setup_util\prepare_deploy.bat
-
In Linux
/opt/jp1dh/server/setup_util/prepare_deploy.sh
When you execute the batch, the command prompt starts. Follow the given instructions. When you have finished preparing to change the application configuration, go to the next step.
(3) Restarting the JP1/DH Web application server
When you are ready to change the application configuration, restart the JP1/DH Web application server. To stop the JP1/DH Web application server temporarily, execute either of the following batches:
-
In Windows
installation-folder\setup_util\stop_webcon.bat
-
In Linux
/opt/jp1dh/server/setup_util/stop_webcon.sh
When you execute the batch, the command prompt starts. Follow the given instructions. If the JP1/DH Web application server normally stops, in the command prompt started in step (1), a message appears notifying you that the JP1/DH Web application server has stopped normally.
Then, execute the operation in step (1) again to start the JP1/DH Web application server.
(4) Changing the application configuration
Execute either of the following batches:
-
In Windows
installation-folder\setup_util\deploy_app.bat
-
In Linux
/opt/jp1dh/server/setup_util/deploy_app.sh
When you execute the batch, the command prompt starts. Follow the given instructions. When you have completed the changing of the application configuration successfully, go to the next step.
(5) Stopping the JP1/DH Web application server
Execute either of the following batches:
-
In Windows
installation-folder\setup_util\stop_webcon.bat
-
In Linux
/opt/jp1dh/server/setup_util/stop_webcon.sh
When you execute the batch, the command prompt starts. Follow the given instructions. If the JP1/DH Web application server normally stops, in the command prompt started in step (3), a message appears notifying you that the JP1/DH Web application server has normally stopped.