Hitachi

JP1 Version 12 JP1/Data Highway - Server Configuration and Administration Guide


5.2.1 New installation, overwrite installation, and upgrade installation (in Linux)

This subsection describes how to newly install JP1/DH - Server.

In Linux, there is no distinction among new installation, overwrite installation, and upgrade installation. For details about overwrite installation and upgrade installation, see the procedure described in this subsection.

First, install Hitachi PP Installer. If Hitachi PP Installer is already installed, execute the following command to start Hitachi PP Installer:

/etc/hitachi_x64setup -i /cdrom

Note: The portion in italics is different depending on your environment.

  1. Log in to the host on which you want to install JP1/DH - Server as a super user. Alternatively, use the su command to change the user to a super user.

  2. For both overwrite installation and upgrade installation, stop JP1/DH - Server in the following order:

    • JP1_DH_WEBSVR (if the JP1/DH Web server is used)

    • JP1_DH_WEBCON

    • JP1_DH_DATABASE_SVR

  3. Insert the CD-ROM containing JP1/DH - Server in the drive.

  4. Mount the CD-ROM device.

    In this example, the command mounts the CD-ROM onto /cdrom:

    /bin/mount -r -o mode=0544device-special-file-name /mnt/cdrom
  5. Execute the following command to install and start Hitachi PP Installer:

    mnt/cdrom/X64LIN/setup /mnt/cdrom

    After Hitachi PP Installer is running, install JP1/DH - Server.

  6. After Hitachi PP Installer is running, the initial window appears.

    An example of the initial window is as follows:

    Hitachi PP Installer 05-16
     
    L) List Installed Software
    I) Install Software
    D) Delete Software
    Q) Quit
     
    Select Procedure ===>
    ...
  7. In the initial window, enter I.

    A list of software programs you can install is displayed.

  8. Move the cursor to JP1/DH - Server, and then select it by using the spacebar. Enter I.

    JP1/DH - Server is installed.

  9. When the installation is completed, enter Q. The initial window appears again.

    Important
    • After the new, overwrite, or upgrade installation of JP1/DH - Server is completed, start the database service (JP1_DH_DATABASE_SVR), and then set up the JP1/DH - Server environment. For details about how to set up the environment, see 5.3 Setting up the JP1/DH Web application server environment. If the JP1/DH Web server is used, see 5.4 Using the JP1/DH Web server.

    • If the installation ends due to an error, the status of the location to which JP1/DH - Server is installed is invalid. In this case, eliminate the cause of that error, start the installer again, make sure that the installer ends normally, and then complete the installation.

    • For the overwrite or upgrade installation, the database-related passwords are reset to p@ssw0rd. Specify them again as needed. For details, see 4.1.3 Notes on overwrite installation and upgrade installation.