9.1 Error handling procedures

This section describes the procedures for handling errors that might occur while you are using JP1/FTP.

1. Check the processing.

   Check the processing event that was underway when the error occurred. If a message has been output, check the details of the message (for the messages, see 8. Messages). For details about the log information that is output by JP1/FTP, see 9.2 Types of log information.

2. Collect data.

   Collect data to determine the cause of the error. For details about the data to be collected, see 9.3 Data to collect when a problem occurs.

3. Check the problem.

   Check the cause of the problem on the basis of the collected data. Also isolate the problem or the affected range.

To Page Top