3.14.1 Registering user names

Use a text editor to specify the necessary information in the definition file (jp1ftpusers.directory_list) according to the definition method described below.

[Figure]

Begin by specifying a definition name, and then specify values on the following lines. If you specify multiple values, make sure that you specify only one value on each line. Any characters following a hash mark (#) through a linefeed are treated as a comment.

Table 3‒17: Definition names and values that can be specified in the definition file (jp1ftpusers.directory_list)
Definition name	Description	Value
`[enable_list]`	Specifies users to whom the function for limiting directory access is to be applied.	`user-name` or `[all]`
`[disable_list]`	Specifies users to whom the function for limiting directory access is not to be applied.	`user-name` or `[all]`

The attributes of this definition file are shown below.

Table 3‒18: Attributes of the definition file (jp1ftpusers.directory_list)
Item name	Setting
File name	`jp1ftpusers.directory_list`
Directory name	`/var/opt/jp1_fts/sys`
Owner	Superuser
Access permission	Owner: `r`

Example

This example definition applies the function for limiting directory access to all users except users root and jp1ftp_user. #ftp is treated as a comment.

[Figure]

To Page Top