9.1 Error handling procedures

This section describes the procedures for handling errors that might occur while you are using JP1/FTP.

1. Checking the processing event

   Check the processing event that was underway when the error occurred. If a message has been output, check the details of the message (for the messages, see 8. Messages). For details about the log information that is output by JP1/FTP, see 9.2 Types of log information.

2. Collecting data

   Collect data to determine the cause of the error. For details about the data to collect, see 9.3 Data to collect when a problem occurs.

3. Checking the problem

   Check the cause of the problem on the basis of the collected data. Also isolate the problem or the affected range.

To Page Top