8.3.4 Messages displayed during execution of the ftsload command

The table below lists and describes the messages that might be displayed when the ftsload command is executed.

Table 8‒8: Messages that might be displayed during execution of the ftsload command
Message that is displayed	Cause	Action
`JP1/FTP` `settings` `are` `recovered.`	(Normal termination)	--
`This` `is` `not` `a` `JP1/FTP` `settings` `storage` `file.`	The specified file is not a JP1/FTP definition information file.	Check and, if necessary, revise the definition information file.
`There` `is` `no` `corresponding` `user,` `so` `there` `is` `no` `auto-start` `program` `settings` `to` `be` `recovered.`	(Normal termination with a warning)	--
`The` `command` `syntax` `is` `incorrect.`	There is a syntax error in the command line.	Check and, if necessary, revise the command line.
`Duplicated` `switch` `-` opt`.`	An option is duplicated.	Do not specify the same option more than once.
`The` `file` `name` `is` `not` `specified.`	The name of the file to be recovered is not specified.	Specify the name of the file to be recovered.
`There` `are` `no` `settings` `to` `be` `recovered.`	The definition information to be recovered is not in the file.	--
`Invalid` `switch` `-` `opt.`	The specified option is invalid.	Check and, if necessary, revise the option.
`Start` `the` `program` `as` `an` `administrator.`	The user who started the command is not an administrator.	An administrator must start the command.