3.17.3 Creating a definition file

Create a definition file by following the procedure described below, and then specify definition information.

Organization of this subsection

(1) To create a definition file

Create a definition file with the following path name:

JP1/FTP-installation-directory\ftsftps.ini

As shown below, information inside the file must be specified in Windows initialization file (.ini) format.

[Figure]

The following table describes the sections, keys, and values you can specify.

Table 3‒22: Information defined in the definition file (ftsftps.ini)
Section	Key	Value	Description
`[FTPS_ServInfo]`	`PrivateKey`	`path-name`	Specify a full path to the private key file of the server.
	`Certificate`	`path-name`	Specify a full path to the server certificate file.
	`FTPSModeOnly`	`YES\|NO` `<<NO>>`	Specify whether to use only FTPS. `YES`: Only FTPS is available. The usual FTP is not available. If you specify `YES`, the JP1/File Transmission Server/FTP Server service would not start unless a value is specified for either `PrivateKey` or `Certificate`. `NO`: Not only FTPS but also the usual FTP is available.

The definition information becomes valid after the JP1/File Transmission Server/FTP Server service starts.