3.4.2 Changing the information registered on a transmission card
You can change the information registered on a transmission card. This subsection describes two methods, one that uses the Registration And Execution Of Transmission Requests window and one that uses a command.
- Organization of this subsection
(1) Using the Registration And Execution Of Transmission Requests window
To change the information registered on a transmission card:
-
In the Registration And Execution Of Transmission Requests window, select the transmission card to be edited, and then choose Change.
The Change Transmission Information dialog box appears.
Figure 3‒12: Change Transmission Information dialog box -
Enter new information in the applicable items.
-
Click Change.
(2) Using the ftsregc command
The following example changes information on a transmission card:
- This example changes the following transmission information on card1:
-
-
/TC: The card name is card2.
-
/TH: The connection-target host name is host1.
-
/TL: The local file name is c:\temp\file1.
-
/TR: The remote file name is c:\temp\file2.
-
For details about the ftsregc command, see ftsregc - registers, changes, deletes, and displays transmission information in 6. Commands.