4.1.4 Job operation function

The following table describes job operations. All operations are executed by commands. For details about the commands, see 9. Commands.

Table 4‒2: List of job operations
No.	Function	Description	Command
1	Register^#	Registers jobs.	`cpajobentry`
2	Delete^#	Deletes an existing job.	`cpajobdelete`
3	Stop (Forced stop)^#	Forcibly stops all running actions and then stops the job.	`cpajobstop -t`
4	Stop (Suspend)	Waits for all running actions to finish and then stops the job.	`cpajobstop -c`
5	Stop (Stop monitoring)	Stops monitoring the execution conditions for the job executed on event are met.	`cpajobstop -e`
6	Retry^#	Reruns jobs.	`cpajobrun`

#: The following operations can be executed also from the Job design view: register, delete, stop (forced stop), and rerun.

If you want to resume monitoring for a job executed on event for which monitoring has been deactivated, you need to take one of the following steps:

Overwrite and then register the job in question by using either the Job Design View or the cpajobentry command.
Restart the job execution service.