KAJM2825-E
Could not monitor InfoPackage-end. (InfoPackage: InfoPackage-ID, request: request-number)
InfoPackage completion monitoring failed.
- S:
-
The system aborts command execution.
- O:
-
Determine the cause by reading the messages displayed before this message as well as the SAP BW system log.
Use the SAP front-end software to check the status of InfoPackage. Abort the execution of InfoPackage if necessary.
If request XXX could not be generated appears in the KAJM0813-E message that appears before this message, a timeout error has occurred in registration monitoring of the data load request. Check whether the registration monitoring time value of the data load request (RequestMonitorTime key in the command section of the environment setup file) is appropriate.