D. Port number to be set
This section explains the port number to be set and the direction through the firewall.
The port number to be used is set to the default and stored in the services file upon delivery of the product.
You can change the port number according to the user environment.
The protocol used is TCP/IP.
The following table shows the protocol number used in JP1/AJS3 - Definition Assistant.
|
Service name |
Port number |
Usage |
|---|---|---|
|
jp1ajs2monitor |
20244 |
Communicate with JP1/AJS3 - Manager |
The direction through the firewall is from JP1/AJS3 - Definition Assistant to JP1/AJS3 - Manager. To set the firewall, at the port of jp1ajs2monitor, the ANY replies to the sessions established on the port number of jp1ajs2monitor should go through.
If you install JP1/AJS3 - Definition Assistant on the firewall server machine, communication on the same machine might also be affected by the firewall. Accordingly, specify the settings so that communication on the same machine is allowed.
JP1/AJS3 - Definition Assistant supports network address translation (NAT) in static mode, but does not support translation between a single global IP address and multiple local IP addresses, such as NAPT (IP Masquerade, NAT+).