Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Messages


KFPS01278-W

Failure to processing log file group. type: aaa(bb....bb),file group: cc....cc,reason code=dddd-ee (L)

The cc....cc log file group used by the bb....bb server will be ignored because the file status cannot be referenced for the reason indicated in dddd.

aaa: Log type (sys or lar)

bb....bb: Embedded database server name

cc....cc: File group name

dddd: Reason code

209: Log file I/O error

213: Log file open error

215: Input to the log file is impossible.

222: Another process is using this file group.

1601: There is no applicable log file.

ee: System maintenance information

(S)

Continues processing, ignoring the log file group indicated in the message.

(O)

There is no problem if you do not use the log file indicated in the message.

  • During execution of the ajsembdbrstr command

    If you have used the log file from the time a backup was obtained until the current time, it may not be possible to recover the database correctly. If the message KFPS01279-W was output, consider its contents, and after contacting the system administrator, take corrective action. After taking corrective action, re-execute the command.

  • For other cases

    Take action according to the reason code, and then re-execute the command. If the message KFPS01279-W was output, take corrective action for the error indicated in the message, and then re-execute the command.

Action

There is no problem if the log file indicated in the message is not required for executing the ajsembdbrstr command. If the log file is required for executing this command, check the following and then take action.

  1. If an error occurred in the log file group or if the log file group was initialized after being used online, check whether the log file can be recovered. If it can be recovered, recover it and then retry.

  2. Check whether the log file specification in the server definition is correct. Correct any error, and then retry.

  3. If neither of the above is applicable, contact system administrator.