KFPS00715-E

An error that prevents further processing of the embedded database occurred.

aaa: Reason code

1: There is a problem with the installation environment of the embedded database.

2: A memory shortage occurred

3, 4, 5, 8, 9, 10, 11, 13, 14, 15, 42, 43, 44, 101, 102, 103, 104, and 105: An attempt to access the system file of the embedded database has failed.

6: Processing to acquire the system time has failed.

7: The embedded database terminated abnormally three consecutive times within 30 minutes during restart processing of the embedded database.

20: The system definition of the embedded database has an error.

(S)

Terminates processing.

Action

Take action as follows:

1. If the ajsembdbstart command did not terminate after this message was output, execute the ajsembdbstop -f command to terminate it.

2. If other messages were output before or after this message, also check those messages.

3. Correct the error indicated by the reason code.

   1:

   - Make sure that installation of the embedded database terminated normally.

   - In UNIX, check whether the /etc/inittab file was unintentionally changed.

   2:

   - Check the status of the running process to make sure that the amount of memory available is greater than the estimated value.

   3, 4, 5, 8, 9, 10, 11, 13, 14, 15, 42, 43, 44, 101, 102, 103, 104, and 105:

   - Check whether the system file of the embedded database was unintentionally changed.

   6:

   - Check the running status of the OS for any problems (for example, insufficient resources).

   7:

   - Check whether all the system log files of the embedded database are full and unable to be overwritten.

   - Check whether the environment settings of the embedded database (such as a directory and port number) duplicate any other settings on the same host.

   - In UNIX, make sure that the character set types of the OS and the embedded database match.

   20:

   - Check whether the system definition file of the embedded database was unintentionally changed.

4. In UNIX, execute the ajsembdbstart -R command.

5. In Windows, restart the embedded database service (JP1/AJS3 Database setup-identifier-name). If the service has not stopped, stop the service and then restart it.

6. If the embedded database does not start automatically, execute the ajsembdbstart command.

7. If the error persists after you take the above actions, contact system administrator.