Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Messages


KFPH00211-I

RDAREA usage aaa%, RDAREA = "bb....bb"cc....cc (L)

The meaning of the message depends on the situation, as shown below:

For users:

Of the segments in the entire RDAREA "bb....bb", the system began to use the segment whose usage is aaa % . The current number of unused segments is cc....cc.

aaa: Segment usage in the entire RDAREA

bb....bb: Relevant RDAREA name

cc....cc: Additional information for the segment usage , dd....dd segments unused

(dd....dd: number of remaining segments)

(S)

Continues processing.

Even if a new segment cannot be allocated due to insufficient space in the RDAREA for which this message is displayed, the system continues processing by adding or updating existing segments when these segments have free space.

After the segment displayed in the message has been released due to deletion or reorganization of the table, this message appears again if the same segment is used.

(P)

Contact the embedded database system administrator.

Action

Execute the ajsembdbstatus -db command to check the free space in the database, and then do the following:

  • Check the additional information about the segment usage output by the ajsembdbstatus -db command or displayed in the message to check the usage of the target RDAREA.

  • Reorganize the table or expand the RDAREA as required.