KAVV3103-E
An error occurred while processing was being performed for SSL communication. (maintenance-information)
An error occurred during SSL communication processing. The probable causes are:
-
A protocol that cannot be used is specified in the SSLProtocol parameter in the ajs2.conf file.
-
The communication encryption function is disabled at the connection destination.
-
The root certificate for the server certificate at the connection destination is not installed.
-
The current time of the host on which an error occurred is earlier than the start time of the effective period specified in the server certificate.
-
The current time of the host on which an error occurred is later than the end time of the effective period specified in the server certificate.
-
A temporary communication error occurred.
-
Connection is restricted by JP1/AJS3 - Manager at the connection destination.
- (S)
-
Cancels processing.
- (O)
-
- If a protocol that cannot be used is specified in the SSLProtocol parameter:
-
Specify a protocol that can be used.
- If the communication encryption function is disabled at the connection destination:
-
Enable the communication encryption function for JP1/AJS3 - Manager at the connection destination.
- If the root certificate for the server certificate at the connection destination is not installed:
-
Install the root certificate for the server certificate at the connection destination.
- If the current time of the host on which an error occurred is earlier than the start time of the effective period specified in the server certificate:
-
Retry the operation after the start time of the effective period specified in the server certificate.
- If the current time of the host on which an error occurred is later than the end time of the effective period specified in the server certificate:
-
Replace the server certificate located on the connection destination host.
- If a temporary communication error occurred:
-
Correct the cause of the error, and then retry the operation.
- If JP1/AJS3 - Manager at the connection destination restricts connections:
-
Add the IP address of the connection source host to the connection permission configuration file for the destination manager.