Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Messages


KAVU0962-E

The job cannot be moved. There are too many queued jobs in destination queue.

You cannot move jobs to the destination queue because the maximum number of jobs that the queue can contain is reached.

(S)

Cancels command execution.

(O)

Either wait for an executing job to end before issuing another request, or check the queue definition information and adjust the maximum number of jobs allowed in the queue.

To check the number of jobs registered in the queue, which is the sum of the QUEUING and EXECUTING values, use the -q or -ah option in the jpqqueshow command. Also, to change the maximum number of jobs allowed in the queue, you can use the jpqquealt command. For details about these commands, see 4. Commands Used for Special Operation in the manual JP1/Automatic Job Management System 3 Command Reference.