KAVU0219-E

The specified queue or agent does not exist.

(S)

Cancels the requested processing.

(O)

Check whether any of the following probable causes are present:

1. You changed the local host name after installing JP1, and then executed a job for the local agent.

2. The agent specified as the execution host in the jobnet or job definition was not defined in the manager.

3. The agent name defined in the manager is invalid.

4. No queue has been added.

5. The queue name or agent was specified incorrectly when a command with a name beginning with jpq was used.

6. The execution host of the job was specified using an IP address.

Take one of the following actions according to the cause of the error, and then re-execute.

1. Change the host name correctly according to 7.9.1 Changing the name of the host that runs JP1/AJS3 in the JP1/Automatic Job Management System 3 Administration Guide.

2. Check the specification of the execution host name. If an incorrect host name is specified, specify the correct one. To add an agent definition to the manager, perform step 3, below.

3. Execute one of the following commands to define the correct agent.

   - For a PC job, Unix job, flexible job^#, HTTP connection job, action job, or custom job:

   ajsagtadd command

   #

   For a flexible job, replace agent with relay agent.

   - For a QUEUE job or submit job:

   jpqimport or jpqagtadd command

4. Use the jpqqueadd command to add a queue.

5. Check the queue name or agent name.

6. As the execution host of the job, specify the name defined as an agent in the manager.

For details about the commands, see 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference and 4. Commands Used for Special Operation in the manual JP1/Automatic Job Management System 3 Command Reference.