KAVS1835-E

An error occurred in the standard error output file or internal file (indicated in file-name).

(S)

If the error occurred when an attempt was made to start a queueless job, the system places the queueless job into the Failed to start status.

If the error occurred while outputting to the standard error output file, the system places the queueless job into the Ended abnormally status.

If the error occurred while transferring the result file when the queueless job terminated, the system places the queueless job into the Ended abnormally status. However, if 1 is specified for the IgnoreResultFileError environment setting parameter, the system places the queueless job into the Ended normally, Ended with warning, or Ended abnormally status based on the end judgment.

(O)

Correct the cause of the error as described below. Then, if necessary, re-execute the queueless job that caused the error.

• If No such file or directory is indicated in maintenance-information-1, the standard error output file indicated in file-name does not exist. Make sure that the standard error output file indicated in file-name exists, and then re-execute the job.

• If Permission denied is indicated in maintenance-information-1, an attempt to read or write to the standard error output file or internal file (indicated in file-name) failed. Set appropriate permissions for the file and directory path so that the mapped OS user can read and write to the standard error output file indicated in file-name. Then re-execute the job.

• If any message other than the above is indicated in maintenance-information-1, correct the error according to the message.

If you cannot correct the problem by taking the above actions, contact the system administrator, and then collect data (see 1.2.3 To the system administrators).

Note:

If the KAVS1859-W message was output before or after this message, an error occurred while transferring the result file. If 1 is specified for the IgnoreResultFileError environment setting parameter, any error that occurs while transferring the result file is ignored. Accordingly, you cannot use the Execution Result Details dialog box of JP1/AJS3 - View to view the contents of the standard error output file.