KAVS0891-E

An error occurred when the manager host on which the jobnet was to be executed notified the manager host where the jobnet was defined that the remote jobnet had ended.

The probable causes are:

• A communication error has occurred between the manager host where the jobnet is defined and the manager host on which the jobnet is to be executed.

• A memory shortage (including a desktop heap that is too small in Windows) has occurred on the manager host where the jobnet is defined or on the manager host where the jobnet is to be executed.

• The scheduler service has not started on the manager host where the jobnet is defined.

• An error occurred in the user mapping for the manager host where the jobnet is defined.

• Communication to the manager host on which the jobnet is to be executed has been restricted because the connection source restriction function is enabled.

(S)

Cancels the end notification processing.

(O)

Correct the cause of the error on the manager host where the jobnet is defined and the manager host where the jobnet is to be executed.

If the status of the remote jobnet on the manager host where the jobnet is defined is Now running, perform the following recovery procedure to place the remote jobnet in the end status:

1. Make sure that the scheduler service has started on the manager host where the jobnet is defined.

2. On the manager host where the jobnet is defined, move to the work folder and execute the following command.

   To execute this command, you must have logged on as a user who has administrator privileges (in Windows) or superuser privileges (in UNIX).

   In Windows:

   JP1/AJS3-installation-folder\tools\ajsremnetrcv.bat

   recovery-information-1 recovery-information-2 recovery-information-3

   recovery-information-4 recovery-information-5 recovery-information-6

   > .\ajsremnetrcv.log

   In UNIX:

   /opt/jp1ajs2/tools/ajsremnetrcv

   recovery-information-1 recovery-information-2 recovery-information-3

   recovery-information-4 recovery-information-5 recovery-information-6

   > ./ajsremnetrcv.log

3. Make sure that the remote jobnet is placed in the end status.

   If the remote jobnet has not been placed in the end status, collect the following data and then contact the system administrator:

   - An error message, if any, output by the ajsremnetrcv command

   - ajsremnetrcv.log

4. Delete the ajsremnetrcv.log file.

Supplementary note

The ajsremnetrcv command is designed for emergency recovery, and cannot be used for any purpose except the recovery procedure described above. Accordingly, the description of this command is not included in the manual JP1/Automatic Job Management System 3 Command Reference.