KAVS0701-E
A unit that is the target of the operation was not found.: unit-name
You executed a command on an active unit automatically selected from under a planning group, but no unit of the target generation could be found.
The probable causes are as follows:
-
There is no unit with the specified path name among the target units that have been automatically selected.
-
You do not have permission to reference the target units that have been automatically selected or the higher-level units of those units.
Use the following methods to execute commands on automatically selected units:
-
Execute the command with yes or auto specified for the -X option and specify the unit name with the root jobnet name omitted under the planning group.
-
Execute the command with YES or AUTO specified for the AJSAUTOJUDGE environment variable and specify the unit name with the root jobnet name omitted under the planning group.
-
Execute the command without the -X option or the AJSAUTOJUDGE environment variable specified, and specify the unit name with the root jobnet name omitted under the planning group.
- (S)
-
Cancels command execution. If you specify more than one unit, the system continues processing of the units of the other jobnets.
- (O)
-
Correct the error, and then re-execute the command.