9.2 Setup for linking JP1/NQSEXEC

This section describes the setup for linking JP1/NQSEXEC to execute jobs.

The following figure shows an example of a system configuration for linking with JP1/NQSEXEC.

Figure 9‒1: Example of a system configuration for linking with JP1/NQSEXEC

In this example, JP1/AJS3 - Manager is linked with JP1/NQSEXEC. JP1/AJS3 - Manager can use a QUEUE job, job execution command to issue a job execution request to JP1/NQSEXEC.

JP1/AJS3 - Manager can also receive an execution request issued by JP1/NQSEXEC.

The following figure shows the setup procedures for linking JP1/NQSEXEC.

Figure 9‒2: Setup procedures for linking JP1/NQSEXEC

For details on setting up JP1/NQSEXEC, see the Job Management Partner 1/NQSEXEC System Administrator's Guide.

The following subsections describe how to specify the port number and register the user information that are required for linking with JP1/AJS3.

Organization of this section

• 9.2.1 Specifying the port number

• 9.2.2 Registering users

• 9.2.3 Cautionary note on linking JP1/NQSEXEC

To Page Top