1.1 Command syntax

This section describes the command syntax, including how to specify a command and the symbols used in the description of the command usage.

Organization of this section

• 1.1.1 Specifying a command

• 1.1.2 Specifying a unit name

• 1.1.3 Specifying a unit name in a command when using a planning group

• 1.1.4 Specifying wildcard characters

• 1.1.5 Specifying an IPv6 address

• 1.1.6 Symbols used in command usage description

• 1.1.7 Remote execution of a command

• 1.1.8 Environment variables for command execution

To Page Top