16.4.1 Execution Agent Management screen

On the Execution Agent Management screen, you can view a list of execution agents and the job execution status of each execution agent.

The following figure shows the Execution Agent Management screen.

Figure 16‒8: Execution Agent Management screen

If you select a execution agent, and then click a button at the top of the screen, you can perform an operation for the execution agent. The following table describes the operations that can be performed by using these buttons.

Table 16‒4: Operations that can be performed by clicking the buttons in the Execution Agent Management screen
No.	Button	Operation
1	Add	Displays the Add Execution Agent dialog box, allowing you to add an execution agent to the connection-destination JP1/AJS3 - Manager.
2	Change Settings	Displays the Change Execution Agent Settings dialog box, allowing you to change the settings of the selected execution agent.
3	Change Status	Displays the following menu items, allowing you to change the job transfer restriction status and the status of an execution agent: Change the Job Transfer Restriction Status Displays the Change the Job Transfer Restriction Status of the Execution Agent dialog box, allowing you to change the job transfer restriction status of the selected execution agent. Change the Execution Agent Status^# Displays the Change the Execution Agent Status dialog box, allowing you to change the status of the selected execution agent.
4	Delete	Deletes the selected execution agents. A maximum of 100 execution agents can be selected at one time.
5	Check the Communication Status^#	Displays the Check the Communication Status of the Execution Agent dialog box, allowing you to start and end the communication status check of the job distribution delay reduction function, and check the check result.
6	Detail	Displays the Detail Information dialog box (for an execution agent), allowing you to check the definitions of the selected execution agent.

#: Before you can use this function, you must enable the job distribution delay reduction function in JP1/AJS3 - Manager. For details about how to enable the job distribution delay reduction function, see 21.5.1 Procedure to enable the job distribution delay reduction function in the JP1/Automatic Job Management System 3 Configuration Guide.

List of screens that can be displayed from the Execution Agent Management screen:

No.	Screen	Relevant section
1	Detail Information dialog box (for an execution agent)	16.30
2	Add Execution Agent dialog box	16.31
3	Change Execution Agent Settings dialog box	16.32
4	Change the Job Transfer Restriction Status of the Execution Agent dialog box	16.33
5	Change the Execution Agent Status dialog box	16.34
6	Check the Communication Status of the Execution Agent dialog box	16.35

To Page Top