12.3.37 Release Suspension dialog box
When a root jobnet being suspended is canceled, the Release Suspension dialog box lets you choose whether a unit added during the execution of the parent jobnet should be executed. The Release Suspension dialog box is shown below.
|
|
![[Figure]](GRAPHICS/ZV140720.GIF)
The following explains the displayed items.
- Jobnet name
-
Specify the name of a root jobnet that should become unsuspended.
- Unit added during execution of parent jobnet
-
Specify the operation available when the parent jobnet of a unit being added during suspension and if the state of suspension is canceled. The default is Execute. For details, see 4.5.17(3)(d) Behavior of added units after suspension is released in the manual JP1/Automatic Job Management System 3 Overview.
- Execute
-
Executes the additional unit when the state of suspension is canceled.
- Do not execute (stop)
-
Does not execute the additional unit when the state of suspension is canceled, but sets up s state of failure to execute a plan.
- Hold
-
Does not execute the additional unit when the state of suspension is canceled, but sets the hold attribute. The additional unit will be executed only when the hold state is removed.