12.3.24 Register Passing Information dialog box
In the Register Passing Information dialog box, you can register or change passing information. The following figure shows the Register Passing Information dialog box.
|
|
![[Figure]](GRAPHICS/ZV140570.GIF)
The following explains the displayed items.
- Variable
-
Specify the macro variable name without the first five characters (?AJS2) and last character (?), as a character string of no more than 58 bytes. You can use upper-case alphabetic characters (A to Z), numeric characters (0 to 9), and periods (.).
- ... button
-
Use this button to select a macro variable name used in an existing unit in the same root jobnet. When you click this button, the Variables Used dialog box appears in which you can select a macro variable name. For details, see 12.3.25 Variables Used dialog box.
- Passing Info
-
Specify passing information by using a character string of up to 255 bytes.
- Cautionary note
-
In Passing Info, do not specify return or tab strokes, or any machine-dependent characters. Doing so may prevent the specified information from being passed correctly when jobnets are registered for execution.
- Supplementary note
-
Specify a variable name so that the total number of bytes# of the macro variable name in the target unit is no more than 1,023.
Also, specify a variable name and passing information so that the total of the number of bytes# of the macro variable name and the number of bytes of the passing information in the target unit is no more than 4,085.
- #
-
Number of bytes obtained by removing from the macro variable name ?AJS2 at the beginning and ? at the end + 4 (unit: bytes)