Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Operator's Guide


11.7.11 Changing the lightness of colors of units that are not highlighted units (base units and preceding and succeeding units)

You can change the lightness of the colors used for units that are not base units, preceding units, or succeeding units when those units are highlighted in the map area in the Jobnet Monitor window. The same lightness level also applies to relation lines between units that are not base units and preceding and succeeding units.

The following table describes the lightness levels and their corresponding transparency.

Table 11‒12: Lightness levels and corresponding transparency (highlighting)

Level

Transparency (%)

Remarks

0

0

The unhighlighted units and relation lines are displayed in the normal manner, not in light hues.

1

10

--

2

20

--

3

30

--

4

40

--

5

50

--

6

60

--

7

70

--

8

80

Default setting

9

90

--

10

100

The unhighlighted units and relation lines are displayed in white (causing them to disappear).

However, you can still select and perform operations (such as deletion) on units and relation lines, so be careful not to operate on them unknowingly or by mistake.

Legend:

--: None.

Specify from:

A JP1/AJS3 - View file (User-specified option file)

For details, see 11.1.1 Types of customization methods.

Specification

Use the following format:

jajsEmphasisLightLevel=0-10 (return)

If you omit this setting, 8 is assumed.

Example

The following specification uses level 5 (50% transparency) to display the units and relation lines that are not base units, preceding units, or succeeding units, or their relation lines.

jajsEmphasisLightLevel=5 (return)