Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Troubleshooting


2.7.3 Action to be taken if the embedded database is unable to terminate

This subsection describes the action to be taken if the embedded database is unable to terminate.

Organization of this subsection

(1) Action to be taken if the embedded database is unable to terminate because processes are connected

The following describes the action to be taken if the embedded database is unable to terminate because processes are still connected.

The embedded database will not terminate until all JP1/AJS3 processes have terminated. Make sure that all JP1/AJS3 services have stopped on the JP1/AJS3 - Manager host and any logical hosts. If a command is being executed, wait for the command to finish before terminating the embedded database. You can use the ajsembdbcancel command to forcibly terminate an executing command.